ICE Meca Tech

Thermal Imaging Camera (13)

Heat Flux Sensor

Overview

Our Heat Flux Sensor is a non-welded sensor that can be easily installed without cutting the furnace wall tubes of large boilers. Instead, an 8mm hole is drilled into the membrane, allowing for seamless assembly. Compared to traditional methods requiring tube cutting, this sensor offers a more convenient installation process.

Heat Flux Sensor on furnace wall

Clamp-type mounting around water tube

Key Features & Benefits

Effortless Installation

: No need for tube cutting, simply-drilling an 8mm hole in the membrane.

Effortless Installation: No need for tube cutting, simply-drilling an 8mm hole in the membrane.

Accurate Heat Absorption Measurement

: Monitors heat transfer in water wall tubes.

Accurate Heat Absorption Measurement: Monitors heat transfer in water wall tubes.

Early Detection of Burner Drift and Local Overheating

: Predicts internal furnace heat distribution.

Early Detection of Burner Drift and Local Overheating: Predicts internal furnace heat distribution.

Optimized Combustion for Reduced Emissions

: Enhances efficiency while minimizing environmental pollutants.

Optimized Combustion for Reduced Emissions: Enhances efficiency while minimizing environmental pollutants.

Fouling Detection on Water Wall Tubes

: Optimizes the operation cycle of the wall soot blower.

Fouling Detection on Water Wall Tubes: Optimizes the operation cycle of the wall soot blower.